Things to do in the spinrg to open the hot tub.
- Remove covering
- Inspect for damage; fix any found
- Close the gate vale drain to road (pics)
- Clean out tub, wash with bleach?
- install fuses, turn on switch at electrical panel (basement bedrrom) (pics)
- fill with plain water to full mark
- open filter cover, fill to allow priming
- turn on gfci panel breaker (pics) (spars?)
- turn on pump pressing ???? on control panel (pivcs)
- the pump should come on; the system is in priming mode for 5 minutes. display will show “Pr”. press the Jet button to tunr the punmp to low speed; fill filter or whevs until priming is complete and water is flowing out of jets
- check for leaks
- run pump in high speed for a few minutres
- check for leacks
- after 5 minutes or pre4ss Temp button. should now bwe in “Standard” mode and heating should start??
- test light
- check for leaks
- await heat to be at desired temperatur
- enjoy hot tub
- 2.
